進階搜尋


下載電子全文  
系統識別號 U0026-1008201221475300
論文名稱(中文) 開圓孔之非均質平板之應力集中
論文名稱(英文) Stress Concentration in Non-Homogeneous Plates with a Circular Hole
校院名稱 成功大學
系所名稱(中) 土木工程學系碩博士班
系所名稱(英) Department of Civil Engineering
學年度 100
學期 2
出版年 101
研究生(中文) 朱茂玄
研究生(英文) Mau-Shiuan Ju
學號 n66991075
學位類別 碩士
語文別 中文
論文頁數 47頁
口試委員 指導教授-譚建國
口試委員-朱聖浩
口試委員-方中
中文關鍵字 應力集中  狀態空間法  傳遞矩陣 
英文關鍵字 stress concentration  state space approach  transfer matrix 
學科別分類
中文摘要 本文採用狀態空間法解析非均質無窮板開洞之應力集中問題。在圓柱座標下,建立非均質無窮板開洞之狀態空間方程式。考慮彈性係數沿徑向為非均質情況下,以有系統的矩陣運算與推導,求得問題之解析解。對特殊非均質型式則採用傳遞矩陣方法,作數值解析。分析結果顯示:
1.彈性係數之漸弱趨勢越大,應力集中現象越顯著,且應力極值均產生於開孔周圍距其內徑五倍範圍內。
2.彈性係數變化趨勢越大,傳遞矩陣位移部份誤差亦較大。
英文摘要 On the basis of the state space approach, stress concentration problems around a hole in a radially inhomogeneous plate is analyzed. The state equations of a hole in a radially inhomogeneous plate is established in the cylindrical coordinates. The numerical analysis method is used through systematical calculation and matrix operation when Young's modulus is radially inhomogeneous. For a general radially inhomogeneous material, transfer matrix is used. Numerical results are presented to investigate the stress concentration around the circular notch. The conclusions show:

1.When Young's modulus's variation is getting smaller and this trend is getting bigger, Stress concentration phenomenon is more obvious, the extreme values of stress all occur in a five times inner diameter area around the hole.

2.When Young's modulus's variation is bigger, the error of displacement by transfer matrix is also bigger.
論文目次 摘要 I
Abstract II
致謝 III
目錄 IV
圖目錄 VI
符號表 VII
第一章 緒論 1
1-1 研究動機 1
1-2 論文大綱 2
第二章 二維圓柱座標系統之基本方程式和傳統解析方法 3
2-1 基本方程式 3
2-2 傳統解析方法 4
2-3 開孔處固定之傳統解析方法 6
第三章 狀態空間之非均質開孔無窮板解法 8
3-1 狀態空間方程式 8
3-2 開孔處未受力 9
3-3 開孔處固定 12
第四章 狀態空間傳遞矩陣之解法 15
4-1 傳遞矩陣之圖形示意 15
4-2 傳遞矩陣之解法詳述 17
4-3 邊界條件 20
第五章 數值結果與探討 22
5-1 形式之分析結果 22
5-2 形式之分析結果 25
5-3 使用傳遞矩陣優劣性 27
第六章 結論 31
參考文獻 32
附錄A 33
附錄B 38
附錄C 43
參考文獻 1.Tarn,J.Q, Tseng,W.D.,Chang,H.H.,A circular elastic cylinder under its own weight.International Journal of Solid and Structures, 46,2886-2896,2009.
2.Tarn,J.Q,Tseng,W.D.,Chang,H.H.,A Hamiltonian State Space Approach for 3D Analysis of circular cantileves.Journal of Elasticity,101,207-237,2010
3.Tarn,J.Q,A state space formalism for anisotropic elasticity.Part I:Rectilinear anisotropic,39,5143-5155,2002
4.Tarn, J.Q., Chang, H.H., Tseng, W.D., Axisymmetric deformation of a transversely Isotropic cylindrical body: A Hamiltonian state-space approach. Journal of Elasticity 97,131-154,2009.
5.Tarn, J.Q., Tseng, W.D., Exact analysis of curved beams and arches with arbitrary end conditions: A Hamiltonian state space approach. Journal of Elasticity 107,39-63,2012.
6.Wang, Y.M., Tarn, J.Q., Hsu, C.K., State space approach for stress decay in laminates. International Journal of Solids and Structures 37,3535-3553
7.Mohsen Mohammadi,John R.Dryden,Liying Jiang,Stress concentration around a hole in a radially inhomogeneous plate,International Journal of Solid and Structures,48,483-491,2011.
8.Mohsen Mohammadi,John R.Dryden,Influence of the spatial variation Poisson's ratio upon the elastic field in nonhomogeneous axisymmetric bodies,International Journal of Solid and Structures,46,788-795,2009.
9.Tarn,J.Q,Wang Y.M,Laminated composite tubes under extension, torsion, bending, shearing and pressuring: a state space approach,International Journal of Solids and Structures 38, 9053-9075, 2001.
10.Tarn,J.Q,Exact solutions for functionally graded anisotropic cylinders subjected to thermal and mechanical loads,International Journal of Solids and Structures, 38, 8189--8206, 2001.
11.Tarn,J.Q, Chang,H.H.,Extension, Torsion, Bending, Pressuring and Shearing of Piezoelectric Circular Cylinders with Radial Inhomogeneity,Journal of Intelligent Material Systems and Structures, 16, 631--641, 2005.

論文全文使用權限
  • 同意授權校內瀏覽/列印電子全文服務,於2015-08-30起公開。
  • 同意授權校外瀏覽/列印電子全文服務,於2015-08-30起公開。


  • 如您有疑問,請聯絡圖書館
    聯絡電話:(06)2757575#65773
    聯絡E-mail:etds@email.ncku.edu.tw